StylPro Heated Anti-fog Bathroom Mirror

• Heated technology
• Build-in LED lights
• Rechargable with USB
• Mounts to wall
• Travel-friendly

Upgrade your bathroom experience with the StylPro Heated Anti-Fog Bathroom Mirror. The rechargeable mirror utilises heat and lights to minimise steam and fog build-up against your shiny surfaces.

Enjoy your steamy showers without the worry of mess or wet with this fog-free mirror. Changing up your bathroom routine, the mirror is infused with heated technology to ensure you always have a streak-free clear reflection. The mirror is also enhanced with built-in LED lights that illuminate your bathroom for your clearest view yet.

Set Contents:

• Anti-Fog Bathroom Mirror
• USB-C Charging Cable
• Wall Suction Mount
• Squeegee

Charging:
1. On the back of the mirror where the On/Off Button is located, carefully lift up the silicon flap to find the USB-C port.
2. Plug the USB-C charging cable (provided) into the USB-C port, plus the other end into a USB-friendly power source.
3. Once your cable is plugged in, the wave symbol will light up green.
4. Once your mirror is charged the green light will turn off. Please then carefully replace the silicone flap ensuring a good seal.

Installation:
1. Choose a flat, gap-free and completely smooth surface (e.g. glass or glossy tiles). Do not mount on rough, bumpy or textured surfaces or across gaps.
2. Clean, rinse and dry the surface with a lint-free cloth. Make sure the surface is completely dry.
3. Rinse the suction cup and dry off any excess water.
4. Using two hands, firmly press the suction cup against your chosen surface and twist the ‘cup mount’ clockwise 45° with considerable force until you feel it ‘lock’. A firm, strong twist will be needed.
5. Check cup is secure. Please note, unlike ‘classic’ suction cups, this cup is only secured after it has been twisted to the locked position. If you stick the cup without locking it, the mirror will fall.
6. With two hands, hold the mirror on either side and firmly push it onto the suction cup ball until it snaps on. Please prepare to push hard. Do not press on the glass.
7. Hook the squeegee onto the neck of the wall suction mount.
8. Should you wish to move or remove the wall suction mount from the surface, twist the mount to the left until fully released. You may need to pull the small tab to remove the wall suction mount from the surface.

How To Use:
1. Use your left hand to reach behind the mirror and long press the On/Off Button. This will turn on the Anti-Fog technology indicated by the wave symbol lighting up red and the LED lights will also turn on. Please do not touch the mirror surface when switched on.
2. Once you have finished with the mirror, use your left hand to reach behind the mirror and long press the On/Off Button to switch off the Anti-Fog technology and LED lights. After 7 minutes of use, the mirror will automatically switch off to minimise battery wastage.
3. If there are any droplets on the mirror, please use the squeegee to clean the mirror.
4. Allow 10 minutes of downtime after every two successive uses.